This project is read-only.

The data flow object ... is not installed correctly on this computer

When I drag the component onto the design surface, I receive a message similar to: "The data flow object "MouldingAndMillwork.SSIS.KimballMethodSCD, KimballMethodSCD90, Version=1.0.0.0, Culture=neutral, PublicKeyToken=8b0551303405e96c" is not installed correctly on this computer."
Conduct the following steps, attempting to use the component after each step:
  1. Close all Visual Studio/BIDS sessions, start BIDS.
  2. Close all VS/BIDS sessions, re-install the component, start BIDS.
  3. Review the Manual Installation instructions on the Installation Instructions page.

Last edited Jun 16, 2010 at 5:45 PM by toddmcdermid, version 1

Comments

No comments yet.